Stamping and embossing were originally two processes in the postpress process, but with the rapid advancement of plate making technology, the use of electric carving techniques to produce a set of Yin and Yang versions can combine the two processes into one. However, if hot stamping and embossing need to be equipped with multiple sets of electric carving yin and yang printing at one time, there will be many problems and it cannot be produced normally. The following combination of their own experience in this regard, introduced an improved process.

1. Problems encountered in using electric carving yin and yang version

We have a batch of paper with a basis weight of about 200 g/m2, and there is a hot silver and embossing registration process. The hot silver and embossed areas are only 4.4cmx1.3cm. Four Chinese characters, five English letters, and one logo are required to be hot silver and embossed. Since the word is too small, if the hot and silver is pressed and then embossed, the stretching and deformation of the paper and some other factors will cause the hot silver and the embossed stamp to be misprinted. To this end, we produced the electric carving yin and yang version, installed on a semi-automatic hot stamping die cutting machine, and installed 5 sets at a time. Although the use of such a process solves the problem of overprinting, the problem of inconsistent pressures between these five editions of hot silver and embossing and pressing is unpredictable. The analysis is considered to be caused by the following reasons.

(1) The precision of the semi-automatic hot stamping die cutting machine is not high, resulting in an unbalanced pressure in the overall machine.

(2) The copper plate is affixed to the hot plate with double-pipe glue (an adhesive), and the application of double-pipe glue on the back of the plate does not evenly result in pressure inconsistency.

(3) There is an error in the engraving of the Yin and Yang plates.

2. Process improvement

The above three reasons have caused the pressure of hot stamping and embossing in the five editions to be unequal. If the pad plate is used on the movable stage, the pressure can be adjusted to be approximately the same, but since the thickest portion of the electric engraving on the movable stage is only 0.68mm, the relief plate will be flattened, although the hot silver effect is still Yes, but no embossing effect.

So I thought of using the flexibility of the blanket to solve this problem. The specific steps are as follows.

(1) Remove the embossing and embossing on the movable table of the machine, take a small piece of air-cushioned blanket with 1.95 mm thickness, and glue it on the movable table with double-sided adhesive.

(2) Adjust the machine pressure to moderate, the original silver paste copper paste stuck on the hot plate does not move, use the pressure of the machine and the elasticity of the blanket to press the paper tightly into the copper intaglio plate.

Under the dual effect of suitable pressure and blanket elasticity, the products produced can not only meet the quality requirements of hot silver, but also achieve the effect of embossing.

In production, due to the small font size, in order to prevent stencils, the hot silver temperature should be controlled between 90 and 100°C, and the place where the pressure of the embossing is insufficient can be adjusted by padding paper of different thickness.

The use of this process has the following advantages.

(1) Do not use embossing and embossing, avoiding overprinting between the negative and positive versions, and avoiding the loss caused by overprinting in the production process.

(2) It is not necessary to install the embossing and embossing plate, and directly paste the blanket, which can greatly save the debugging time and improve the production efficiency.

(3) The cost of plate making can be saved by not pressing the concave and convex printing plate.